Remote Programming Procedure

Programming New Remote to Receiver

  1. Press and hold SW1 (for channel 1) or SW2 (for channel 2)

on the receiver board (garage door motor). The LED D1 will

start to flash.

  1. Press the remote button you would like to use to control the

device for two seconds.

The LED will start to flash faster.

  1. Release the remote button and pause for two seconds. Press

the same button again for two seconds. The LED will stay on

for a second and then turn off.

  1. Release SW button.

Deleting a Single Remote from Receiver

  1. Press and hold SW1 (for channel 1) or SW2 (for

channel 2) on the receiver board (garage door

motor.) The LED D1 will start to flash.

  1. Press the transmitter button you would like to

remove from receivers’ memory for two seconds.

The LED will start to flash faster.

  1. Release the transmitter button and pause for two

seconds. Press the same button again for two

seconds. The LED will slowly flash two times.

  1. Release SW button.

 

Deleting All Remotes from Receiver

  1. Turn the power off to the receiver (garage door motor.).
  2. Press and hold SW1 button.
  3. While holding SW1 turn power on again. After 15 seconds the

Coding LED will light up to indicate that the receiver’s memory

has been cleared.

  1. Release SW1. All the stored codes should now be deleted.